PT6 Starting question
Thread Starter
Join Date: Aug 2003
Location: LOS
Age: 67
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
PT6 Starting question
So all the helicopters I have flown with the exception of the S61 do not have a separate igniter switch, meaning the starter button did both the starter and the igniters simultaneously. My Nephew is just getting into a turbine with an AirTractor for crop spraying and it has a PT6. This FW has a separate ignitor switch and the procedure in the manual is to activate the starter and at 10-12% activate the ignitor switch just prior to inducing fuel. Why would this be different for basically the same engine as a 212/412/Aw139? Seems like an unnecessary step to me.
Any P&W reps out there that can explain the reason for that?
Any P&W reps out there that can explain the reason for that?
It could be a requirement set by AT, rather than P&WC and if the case, I suspect to reduce the likelihood of a hot start, as it allows the pilot to ensure they have good NG speed prior to lighting it up. I was always a fan of holding back on opening up the fuel tap, until the NG was higher than published minimum data, so as to get a much cooler start. Of course, a good battery and preferably external power makes this a lot easier.
Additionally, the AT has a nose high attitude, so unburnt fuel that does not drain out, is likely to run down the GG case and sit around the exit of the lower diffuser tubes, just waiting for the next start.
Additionally, the AT has a nose high attitude, so unburnt fuel that does not drain out, is likely to run down the GG case and sit around the exit of the lower diffuser tubes, just waiting for the next start.
Ag machines are pretty rudimentary.
START - dry motoring run
START + IGNITER ON - start
IGNITER CONTINUOUS - self explanatory used in inclement weather conditions
Igniter can be left in ON position after start as it only will operate with starter. Maybe the selection at 12% avoids a hot start from wet combustion section? AG Model PT6’s have high TBO’s and some run on diesel in certain circumstances.
Lots of helicopter PT6 out there without FADEC. 212/412?
AC did you mean “The Big Fella’s” B model?
START - dry motoring run
START + IGNITER ON - start
IGNITER CONTINUOUS - self explanatory used in inclement weather conditions
Igniter can be left in ON position after start as it only will operate with starter. Maybe the selection at 12% avoids a hot start from wet combustion section? AG Model PT6’s have high TBO’s and some run on diesel in certain circumstances.
Lots of helicopter PT6 out there without FADEC. 212/412?
AC did you mean “The Big Fella’s” B model?
The Quest Kodiak has a PT-6 and a separate igniter switch.
(Note: When doing a dry motoring run don't forget to pull the igniter CB or switch off the igniters before hitting the start button - I heard there was a bit of excitement dry motoring an AW139 in the hangar that wasn't so dry somewhere this week...ooops).
(Note: When doing a dry motoring run don't forget to pull the igniter CB or switch off the igniters before hitting the start button - I heard there was a bit of excitement dry motoring an AW139 in the hangar that wasn't so dry somewhere this week...ooops).
Thread Starter
Join Date: Aug 2003
Location: LOS
Age: 67
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
Ag machines are pretty rudimentary.
START - dry motoring run
START + IGNITER ON - start
IGNITER CONTINUOUS - self explanatory used in inclement weather conditions
Igniter can be left in ON position after start as it only will operate with starter. Maybe the selection at 12% avoids a hot start from wet combustion section? AG Model PT6’s have high TBO’s and some run on diesel in certain circumstances.
Lots of helicopter PT6 out there without FADEC. 212/412?
AC did you mean “The Big Fella’s” B model?
START - dry motoring run
START + IGNITER ON - start
IGNITER CONTINUOUS - self explanatory used in inclement weather conditions
Igniter can be left in ON position after start as it only will operate with starter. Maybe the selection at 12% avoids a hot start from wet combustion section? AG Model PT6’s have high TBO’s and some run on diesel in certain circumstances.
Lots of helicopter PT6 out there without FADEC. 212/412?
AC did you mean “The Big Fella’s” B model?
AG PT6's only have high (on condition) TBO's in the US and 212's are routinely operated on winter diesel in northern Canada.
I would also guess that it is just an additional safeguard against hot starts due to premature or residual fuel in the combustion chamber. Maybe AT found it prudent to add this step while Helicopter manufacturers didn't. On the AW119 the igniters also fire as soon as the starter engages.
Never flew a turbine helo that had a ignition switch. Never has trouble ever starting a 212 or 412 (non fadec PT-6), no tendency to over temp, but that was all sea level operations.
Fixed wing manuals I have powered by PT-6 all have separate starter and ignition switches, one single engine even has a caption warning if the ignition is on when the engine is running with the advice if not flying in rain then turn it off. Outwest, the start on the Thrush is exactly as you describe for the Air Tractor.
King Air system.
The engine ignition system is a high-energy, capacitance type consisting of a dual-circuit igniter box and two igniter plugs in the combustion chamber. The ignition system is divided into starting ignition and autoignition.
STARTING IGNITION
A three-position lever lock switch for each engine controls this system. The switch is located on the left switch panel. It has three marked positions: ON–OFF–STARTER ONLY. The ON position (UP) is lever locked and it provides for engine cranking and ignition operation. The STARTER ONLY position is a momentary (spring loaded to center hold down) position and it only provides for engine motoring. In this position, the igniters do not function.
AUTOIGNITION
The autoignition system is controlled by a two-position switch for each engine marked ARM and OFF. Turning on an AUTO IGNITION switch arms the igniter circuit to an engine torque switch that is normally open when the engine is developing more than 400 foot-pounds of torque. The system must be armed prior to takeoff and for all phases of flight, and it should be turned off only after landing. If engine torque drops to 400 foot-pounds or less when the autoignition is armed, the ignition system will energize to prevent engine flameout if the loss of power was caused by a momentary fuel or air interruption.
Fixed wing manuals I have powered by PT-6 all have separate starter and ignition switches, one single engine even has a caption warning if the ignition is on when the engine is running with the advice if not flying in rain then turn it off. Outwest, the start on the Thrush is exactly as you describe for the Air Tractor.
King Air system.
The engine ignition system is a high-energy, capacitance type consisting of a dual-circuit igniter box and two igniter plugs in the combustion chamber. The ignition system is divided into starting ignition and autoignition.
STARTING IGNITION
A three-position lever lock switch for each engine controls this system. The switch is located on the left switch panel. It has three marked positions: ON–OFF–STARTER ONLY. The ON position (UP) is lever locked and it provides for engine cranking and ignition operation. The STARTER ONLY position is a momentary (spring loaded to center hold down) position and it only provides for engine motoring. In this position, the igniters do not function.
AUTOIGNITION
The autoignition system is controlled by a two-position switch for each engine marked ARM and OFF. Turning on an AUTO IGNITION switch arms the igniter circuit to an engine torque switch that is normally open when the engine is developing more than 400 foot-pounds of torque. The system must be armed prior to takeoff and for all phases of flight, and it should be turned off only after landing. If engine torque drops to 400 foot-pounds or less when the autoignition is armed, the ignition system will energize to prevent engine flameout if the loss of power was caused by a momentary fuel or air interruption.
Thread Starter
Join Date: Aug 2003
Location: LOS
Age: 67
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
Never flew a turbine helo that had a ignition switch. Never has trouble ever starting a 212 or 412 (non fadec PT-6), no tendency to over temp, but that was all sea level operations.
Fixed wing manuals I have powered by PT-6 all have separate starter and ignition switches, one single engine even has a caption warning if the ignition is on when the engine is running with the advice if not flying in rain then turn it off. Outwest, the start on the Thrush is exactly as you describe for the Air Tractor.
Fixed wing manuals I have powered by PT-6 all have separate starter and ignition switches, one single engine even has a caption warning if the ignition is on when the engine is running with the advice if not flying in rain then turn it off. Outwest, the start on the Thrush is exactly as you describe for the Air Tractor.
I appreciate all the comments from everyone but I would really like a P&W rep to explain the difference, any reps out there?
Yup I have seen the PT-6 start with the throttle at idle and, yes, it works because of the flow divider , but why do it? You could do the same thing with the T53 on the 205.
Trying it on a 250 and you are buying a new hot section…you will never be fast enough to close the throttle before the needle pegs. More than one 250 has been “Boat Anchored” due to the pilot not checking the throttle position of carrying out the throttle check incorrectly.
One fellow returned from lunch and found the throttle in the full open position, someone had entered the cockpit and fooled around. Fortunately we had a policy of turning the fuel valve OFF, pulling the ignitor CB and then.disconnecting the battery before leaving the aircraft unattended.
Some folks get confused between a cooling run to lower residual temp before a start with ignitors on and a drying run to blow residual fuel out of the engine if the darned thing didn’t light off on the first attempt. ( Happened from time to time with a cold soaked engine and Jet-A ) in which case the ignition CB would be pulled to avoid loud noises startling the engineer. I miss good old Jet-B.
Trying it on a 250 and you are buying a new hot section…you will never be fast enough to close the throttle before the needle pegs. More than one 250 has been “Boat Anchored” due to the pilot not checking the throttle position of carrying out the throttle check incorrectly.
One fellow returned from lunch and found the throttle in the full open position, someone had entered the cockpit and fooled around. Fortunately we had a policy of turning the fuel valve OFF, pulling the ignitor CB and then.disconnecting the battery before leaving the aircraft unattended.
Some folks get confused between a cooling run to lower residual temp before a start with ignitors on and a drying run to blow residual fuel out of the engine if the darned thing didn’t light off on the first attempt. ( Happened from time to time with a cold soaked engine and Jet-A ) in which case the ignition CB would be pulled to avoid loud noises startling the engineer. I miss good old Jet-B.
I have no knowledge as to why but if all/most fixed wings have seperate ignition circuits perhaps it hearkens back to removing electrical power from a piston engine propellor free wheeling in the slipstream or turbines with fixed power sections? Do turbine aeroplanes have freewheeling units?
I’m certainly glad they don’t have that system on the helicopter PT6. Opening and closing the throttle then modulating and using the starter and also activating the idle detent is already a bit of a dance of the hands.
It is an interesting question.
I’m certainly glad they don’t have that system on the helicopter PT6. Opening and closing the throttle then modulating and using the starter and also activating the idle detent is already a bit of a dance of the hands.
It is an interesting question.
Thread Starter
Join Date: Aug 2003
Location: LOS
Age: 67
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
I’m certainly glad they don’t have that system on the helicopter PT6. Opening and closing the throttle then modulating and using the starter and also activating the idle detent is already a bit of a dance of the hands.
I’m certainly glad they don’t have that system on the helicopter PT6. Opening and closing the throttle then modulating and using the starter and also activating the idle detent is already a bit of a dance of the hands.
Join Date: Jan 2009
Location: On a survey line somewhere...
Age: 41
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
Yes, exactly why I'm asking this. My nephew tells me of a couple ways different pilots have told him on which finger/thumb combination to use to accomplish this dance. I told him I would not do this digital gymnastic and risk my finger slipping off the starter part way thru the start after light-off.
Realistically, there are very few cases where an inflight relight with starter should be required in that airplane, and fewer where there will be enough altitude for it. Most likely need for it would be fuel mismanagement on a ferry flight using fuel in the hopper, I think. On the ground though, with both hands available it's quite easy.
Thread Starter
Join Date: Aug 2003
Location: LOS
Age: 67
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
Hah, yeah. The other thing with the Air Tractor setup is that it requires right hand for the panel mounted start and igniter switches, sort of braced so that the finger on the spring loaded starter doesn't accidentally come off it, but so that you're able to also actuate the igniter switch once past about 12% Ng. The left hand is required for the condition lever. So.... In the unlikely event that an inflight relight using starter was to be required, and there was enough altitude to accomplish it, the stick must be held with one's thighs....
Realistically, there are very few cases where an inflight relight with starter should be required in that airplane, and fewer where there will be enough altitude for it. Most likely need for it would be fuel mismanagement on a ferry flight using fuel in the hopper, I think. On the ground though, with both hands available it's quite easy.
Realistically, there are very few cases where an inflight relight with starter should be required in that airplane, and fewer where there will be enough altitude for it. Most likely need for it would be fuel mismanagement on a ferry flight using fuel in the hopper, I think. On the ground though, with both hands available it's quite easy.